Description
ICC1-IRX – Overview
The new ICC1-IRX IR TV Controller delivers economical 1-way control for TV power, volume, and channels, receiving iCC-Net network commands over the same broadband coax that carries the CATV channels. Compact in size and price, the ICC1-IRX now features power current sensing using the optional CSM1 sensor from Xantech.
Controls most brands of IR-controlled TVs.
-
Features:
- Manages channel access by changing the TV’s internal available channel list
- Delivers absolute power control using the Xantech CSM1 power current sensor
- Networks up to 4,000 TVs through the ICE-HE Ethernet Head-End
- Receives 1-way individual and zone commands from a single RS-232 port on the HE
- Operates over same RF coax cable as CATV channels
- Exclusive SmartZone architecture controls hundreds of controllers with a single command
- Low-loss internal RF tap saves amplification and installation costs
- Provides LED feedback for network, IR control, and power status
- Restores all power and channel status after loss of power from data stored in non-volatile memory
- Mounts on the back of the TV for simplified control and RF installation
- Operates with Contemporary Research Display Express software as well as from RS-232 protocol from a custom-programmed PC or control system
- Senses power status from optional CSM1 power current sensor, or optional CC-HSD scan sensor for older tube TVs
-
Specifications:
- PHYSICAL
- Size: 5.5″ [140mm] wide x 1.1″ [28mm] high x 3.4″ [86mm] deep
- Weight: 8 oz [226g]
- Enclosure: All aluminum with durable black powder coat paint
- Mounting: Mounts at rear of TV
- FRONT PANEL
- RF In: ‘F’, female, 75 ohm impedance, RF from CATV system, iCC-Net control
- RF Out:
- – `F’, female, 75 ohm impedance, RF to TV
- – Low-loss internal tap – less than -1.5 dbmV loss
- Net LED: Green LED for iC-Net bus and DC power, flashes once per second if active
- IR Out:
- – 3.5mm jack for CC-IRE IR Emitter cable or compatible CC-IRS serial cable
- – Supports carrier frequencies up to 62 KHz
- IR Out LED: Red LED lights when sending IR commands
- Power Sensor:
- – Tip+:3.5mm jack for included CC-HSD scan sensor or 5V logic-level input
- – CSM: 3.5mm jack of Zantech CSM1 Power Current Sensor
- – LED: Red LED lights when sensor indicates power on
- Power In: 2.1mm coaxial jack (inside center conductor positive), 75 mA maximum
- 11.5 to 16.5 VDC, 12 VDC typical (may be unregulated)
- DIP Switches S1 and S2: Located on bottom of unit, sets IR code operation and device number
- ICC-NET
- Operation: 1-way control, carried over the same RF coax connection as TV channels
- Data Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller , -25 to +35 dBmV signal level
- CC-HSD SCAN SENSOR
- Range: Senses presence of TV scanning, from 15-35 KHz, magnetic pick-up
- Includes: 3.5mm plug, 4ft. cable, stick-on TV sensor
-
Item Includes:
- CC-IRE IR Emitter
- RF loop cable
- Mounting Velcro
- 12VDC power supply (U.S. only)